Forum: Line and Cable Modeling

Hello I am trying to simulate a power system with DG and to see the fault current when the feeder has a fault .The voltage of my feeder is...

Hello I am trying to simulate a power system with DG and to see the fault current when the feeder has a fault .The voltage of my feeder is...

Hi, I want to model the fault current distribution along the groundwire (shieldwire/earthwire). The line tower footing resistance is an important...

Dear everyone Iamstudyind about the fault of feeder, i want to add relay to protect my feeder. The tripping time of relay is...

hi every one i want to model a TL in my simple exzample for fualt analyse but i can not input line sequence parameters i attache my example for...

Hi, I am new user to PSCAD v4.1.1. I wish to carry out fault analysis of MV line (69kV) system with high SIR (around 30), such that fault current...

hi all , Itry to built a 4-circuit transmission line model in PSCAD 4.2.0 , I only want to build simple P-I circuit for each , but in PSCAD model...

Our apologies if you receive multiple copies of this Call for Papers ========================================= Education Track within CSSE ...

I found that there is L. Marti paper among refereces in EMTDC user's guide. Is it also supported 'Frequency dependent (mode) model?

Hello, In attachment you can see problem description with scheme. Main question is how I can model buried copper wire along underground cable?...

I have built up one 1phase cable. Now I want to testthe viariance of its impendence with the different Frequences ( from 1 Hz to 1 Mega Hz). Could...

Does anybody has any insight to using PSCAD for simulating induced sheath voltages in a cross bonded cable system. Thanks Ven

Hi! I've simulated the fault in 3 lines system using Tline. But how can I alert the patameters like resistance、capacitance? Could someone teach...

Hello I have 2 different ground wires, but data can be entered only on one wire. Is it possible to enter two different data groups.

Hi all Friends! I am Tring to model a network By ETAP Software.I have a problem to calculate and Enter the amount of 3ph & 1Ph MVA Short Circuit...

Can someone explain to me about frequency dependence phase model option in transmission line… what including in that configuration? How to setting...

Hi All, I'm trying to model a 5km long (crossbonded) UG cable system and observe it's transients behaviour for each cable model used (PI section,...

Hello, I have been playing around with the student edition for a while. I seem to be have the maximum trouble with the cable interface. Will...

Hi folks! I was wondering if anyone could provide me with a sample circuot that uses underground cables. I tried to find one of these from the ...

I'm now trying to measure the capacitivecoupled zero sequence voltage betweenthe double-circuit tlines, here are the problems: I set the voltage...